Introducción

Use this repair guide when debris needs to be cleared from the On/Off switch or it needs to be replaced.

  1. Take the battery cover off by releasing the locking tab and hinging the cover away.
    • Take the battery cover off by releasing the locking tab and hinging the cover away.

    Agregar Comentario

  2. Remove the six back panel screws using a Tri-wing Screwdriver.
    • Remove the six back panel screws using a Tri-wing Screwdriver.

    Agregar Comentario

    • Remove bottom back panel screw with a Phillips #1 screw driver.

    We recommend you change the the screw head to a Phillips 1 so you don't strip the screw. (Something we experienced)

    Adriano Agostino - Contestar

    • Remove the back panel by pulling away with one hand and the front secured in the other hand.

    • Removal of the back panel may cause shoulder buttons and side panels to come loose and fall off.

    Agregar Comentario

    • Remove left and right triggers by lifting and pulling them away from the system.

    • Do the same for side panels

    • For finicky or jammed triggers only. Adjust and correct triggers and reassemble. Most jammed triggers are caused by buttons misplaced or jammed in its enclosure.

    Agregar Comentario

    • Remove the gray On/Off Switch by pulling up and away from the unit. Replace with another switch if necessary.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Adam

Miembro Desde 20/01/10

642 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 16-29, Maness Winter 2010 Miembro de Cal Poly, Team 16-29, Maness Winter 2010

CPSU-MANESS-W10S16G29

5 Miembros

26 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 13

Últimos 30 Días: 74

Todo El Tiempo: 12,417