Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the plastic opening tool into the SD card slot or charge port.
-
Try in an upward motion until you see a separation between the tablet and back cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Work around the entire device by sliding the plastic opening tool around the rim.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the back cover once all links have been separated.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Starting with the right speaker, remove the 10 mm Phillips #000 screws.
-
Use the spudger to begin pulling out the speaker.
-
Wedge the spudger beneath the amplifier to remove it from the adhesive holding it down.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 10mm Phillips #000 screws that hold the left speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
Herramienta utilizada en este paso:Tweezers$4.99-
Take a pair of tweezers and disconnect the left battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the same pair of tweezers to begin removing the left speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the speaker out and lay it to the side until the rest of the connections are disconnected.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There are four slots that are located along the border that can be used to remove the strip that is glued to the side.
-
Wedge the tweezers in each slot to carefully remove the strip.
-
Cancelar: No complete esta guía.
4 personas más completaron esta guía.
3 comentarios
Absolutely right. See my comment above. Carefully prising with the right tools between the display and the frame - the bezel - and working around the outside of the display will eventually cause the bezel to come away from the display with the back cover attached. You can then access the parts you need to get to.
Suggestion….add the necessary step of removing the frame that covers the left speaker. If you follow the instructions in this guide, you will not be able to access and remove the left speaker, which is critical considering the on off and volume switches are integral to the speaker.