Introducción
The G&G m-14 is actually quite different than the Tokyo Marui m-14 but in many ways this actually makes it MORE compatible with after market parts and upgrades, and it's much easier to disassemble.
The G&G m-14 takes the same barrels as v2 v3 AEG unlike the marui that requires a unique slotted barrel. The G&G also takes standard v2/v3 gears unlike the marui m-14 that once again take model specific gears. These differences are being stated because there is often confusion where people are told to purchase m-14 specific gears and barrels when they can just use and standard parts that are normally referred to as "Marui compatible". Basically what I am trying to say is that the G&G m14 is more "Tokyo Marui compatible" as we have come to know it then the actual Marui m-14. It's a good thing!
Qué necesitas
-
-
The first step as with most AEG's is cyle the AEG on semi-auto twice to set the piston in the rest position and clear the chamber of any bb's.
-
Then Remove the battery and keep the back hatch open.
-
-
-
To begin the disassembly put the safety to the safe position.
-
This will allow you to pull on the back of the trigger guard as shown and hinge the the trigger guard out ward.
-
Next pull downward on the entire trigger mechanism as it will come straight out.
-
The cool part about this step is it's exactly like the real firearm and it serves the exact same function.
-
-
-
-
The next thing to do is remove the bolt catch. This will give you access to the small screw behind it which is part of the next step.
-
Punch out the the pin with either a thin punch or other appropriate tool. Once the pin is partially sticking out you can grab it with pliers.
-
Careful not to loose track of the spring behind the catch.
-
-
-
Once the gearbox is opened up quickly remove the main spring and spring guide so that nothing goes fly away.
-
After this point you can remove the gears. Just as in the other guide try not to misplace the shims unless you want to adjust the shimming yourself.
-
Check out the G&G AEG Shimming Guide Airsoft guide for more shimming info.
-
-
-
This step is going to cover some of the unique parts of the G&GM-14.
-
The first part people notice is the unique Anti-reversal latch. This piece can be pulled right out. The spring that is attached is almost identical to those found in version 2/3 gearboxes and functions in the same way.
-
Next part is the selector piece. This part interacts with the selector on the gun and will make your gun go full-auto or semi-auto depending on it's position. if you flip the gearbox over you can actually see how it directly interacts with the cut-off leaver.
-
It should be left alone but just encase it does need replacement there is a screw on the out side allowing it to be removed.
-
Lastly there is the trigger switch. This piece is pressed into place and once the spring is detached from the gearbox post, the switch can be pulled out as shown.
-
Cancelar: No complete esta guía.
6 personas más completaron esta guía.