Fujifilm FinePix XP50 LCD Screen Replacement

Introducción

If the LCD screen is damaged or malfunctioning, replacing with a new one may solve the issue. Most of the camera has to be taken apart in order to remove the screen.

Qué necesitas

Paso 1 Battery

Fujifilm FinePix XP50 LCD Screen Replacement, Battery: paso 1, imagen 1 de 1

Power off the camera.
Leaving the camera on while removing presents the risk of electrical shock or permanent data loss.

Editar

Paso 2

Push down on the center button and turn the dial on the side counterclockwise to open the battery compartment.

Editar

Paso 3

Pull the orange tab towards the hinge to release the battery.

Editar

Paso 4 Button

Fujifilm FinePix XP50 LCD Screen Replacement, Button: paso 4, imagen 1 de 2

Fujifilm FinePix XP50 LCD Screen Replacement, Button: paso 4, imagen 2 de 2

Pry the black button plate off using a plastic opening tool.
Buttons can fall out easily.
It's easiest to start from the side exposed by an open battery compartment.
When putting this plate back on, orientate the buttons as shown to properly fit back into the plate.

Editar

Paso 5

Pull the three buttons out.

Editar

Paso 6 Front and Back Panel

Fujifilm FinePix XP50 LCD Screen Replacement, Front and Back Panel: paso 6, imagen 1 de 1

Remove one Phillips screw with a Phillips head 0 screwdriver
Remove one hex head screw with a hex 1.3 screwdriver bit.

Editar

Paso 7

Unscrew two 4.0mm long hex head screws with a hex 1.3 screwdriver bit.

Editar

Paso 8

Unscrew five 4.0mm screws with a Phillips head 0 screwdriver

Editar

Paso 9

Pry the black bottom plate off using a plastic opening tool.
It is easier to start on the side of the open battery compartment.

Editar

Paso 10

Pry the front plate off using a plastic opening tool.
It's recommended to start at the ridge on the top or bottom side.

Editar

Paso 11

Lift off the front plate.

Editar

Paso 12

Fujifilm FinePix XP50 LCD Screen Replacement: paso 12, imagen 3 de 3

Pry the back plate off with a plastic opening tool

Editar

Paso 13 Back Panel

Fujifilm FinePix XP50 LCD Screen Replacement, Back Panel: paso 13, imagen 1 de 1

Pry the two latches off using a spudger.
It takes some force to pry the latches off, so be careful to not break them.

Editar

Paso 14

Fujifilm FinePix XP50 LCD Screen Replacement: paso 14, imagen 3 de 3

Pry the remaining latches with a plastic opening tool.
It's best to start on the opposite side. Then pry off the top and end at the bottom.
It may take some force to remove this, but be careful to not break the latches off.