Fujifilm FinePix S4200 Viewfinder Replacement

Introducción

To replace the viewfinder you will need to perform the LCD prerequisite. The viewfinder should be replaced if your camera does not focus or your photos lack composition.

Qué necesitas

Paso 1 LCD Screen

Fujifilm FinePix S4200 Viewfinder Replacement, LCD Screen: paso 1, imagen 1 de 1

Turn the camera off.
Turn the camera upside down so that the battery compartment is showing.

Editar

Paso 2

Remove the three 4 mm screws from the bottom of the camera with a Phillips #000 screwdriver.

Editar

Paso 3

Rotate camera to the side where the speaker ports are located.
Remove the three 4 mm screws with a Phillips #000 screwdriver.

Editar

Paso 4

Turn the camera to the opposite side where the HDMI port is located.
Remove all five 4 mm screws with a Phillips #000 screwdriver.

Editar

Paso 5

Fujifilm FinePix S4200 Viewfinder Replacement: paso 5, imagen 3 de 3

Casing is fragile.
Utilize the plastic opening tool to pry in between the back casing of the camera from the front casing.
Continue this motion around the camera to create a wedge between the front and back casing of the camera.

Editar

Paso 6

Use force to pull apart the back casing from the camera.

Editar

Paso 7

Remove the two 4 mm screws that hold the motherboard and metal plate in place.

Editar

Paso 8

Utilize the plastic opening tool to gently lift the LCD screen away from the metal plate.
Flip over LCD screen so that the left side of the metal plate is visible.

Editar

Paso 9

Rotate the camera vertically so that it is easier to manage.
Use a Phillips #000 screwdriver to remove the two 4mm screws that are located on the metal plate under the LCD screen.

Editar

Paso 10

Detach the metal plate from the motherboard.

Editar

Paso 11

The orange ribbon cable is fragile.
Pull back the small black latch connecting the orange ribbon cable to the motherboard.
Gently remove the LCD screen from the motherboard.