Fujifilm FinePix S4200 Lens Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

Use this guide to replace the lense in the Fujifilm Finepix S4200. This guide requires the use of a Phillips 000 screwdriver and soldering iron. Previous soldering experience is recommended.

Qué necesitas

Paso 1 Lens

Fujifilm FinePix S4200 Lens Replacement, Lens: paso 1, imagen 1 de 1

Turn off the camera by pushing the ON/OFF switch as shown.

Traducir

Paso 2

Fujifilm FinePix S4200 Lens Replacement: paso 2, imagen 3 de 3

Using a Phillips #000 screwdriver, remove all of the 4mm screws from the left, right, and bottom of the camera.

Traducir

Paso 3

Remove casing part pictured by gently pulling up until casing is fully detached.

Traducir

Paso 4

Fujifilm FinePix S4200 Lens Replacement: paso 4, imagen 3 de 3

Remove the 4 mm screws on the metal plate. Then remove the 4 mm screws on left side of the camera, and remove the two 4mm screws on right side.
Use the Phillips #000 to avoid stripping the screws.

Traducir

Paso 5

Remove orange ribbon cable by gently pulling on the cable until it is detached from the clamping device on the motherboard.
Remove the top casing by pulling upwards.

Traducir

Paso 6

Carefully remove the LCD screen.
Gently pull on orange tab until it is free. This orange strip is susceptible to tearing.

Traducir

Paso 7

Remove remaining 4mm screw. Detach metal plate by lifting plate upwards.
Use the Phillips #000 screwdriver.

Traducir

Paso 8

Remove remaining orange tabs on motherboard by gently pulling on all tab until they are free.
Caution: Orange strips are susceptible to tearing.

Traducir

Paso 9

Using the Phillips #000 screwdriver, remove the 4mm screws in the corners of the motherboard.

Traducir

Paso 10

Use a soldering iron to desolder the five connections shown.
Caution: After removing the soldered connections, they must be given ample time to cool before moving to the next step.

Traducir