Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the latch on the battery door marked by the word "BATT." Use your finger to pry it open.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the battery from the camera by pulling the battery door outwards.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate and remove three black 3.80mm screws on the back of the camera with the Phillips #00 screwdriver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate and remove the 6.4mm screws located on either side of the camera with a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the film door latch located on the side of the camera.
-
Insert the spudger under the latch.
-
Pry the latch upward, applying force perpendicular to the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the flat edge of the spudger between the gold front casing and the black back casing.
-
Pry the spudger upward until the black back casing snaps out and is dislodged on that edge of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Squeeze the camera by placing a thumb on the tab marked CE.
-
Pull the back half of the camera firmly away from the camera body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate and remove the 3.80mm screw inside the film compartment with the Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the front cover off of the camera by lifting the tripod tab over the tripod hole.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the film door on the bottom of the camera.
-
Locate the pin that connects the film door to the camera
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Push the pin from one side with the spudger until it comes out on the opposite side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grab the pin with the tweezers and gently pull it out.
-
The film door should feel lose.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the door with your fingers and discard it.
-
Insert the replacement film door appropriately to fit where the broken door was located.
-