Introducción

Remove and replace LCD screen.

Remove the batteries from the camera to prevent danger of electric shock.
  • Remove the batteries from the camera to prevent danger of electric shock.

Agregar Comentario

Locate all five screws on the camera. Then proceed to remove all the screws.
  • Locate all five screws on the camera. Then proceed to remove all the screws.

Agregar Comentario

  • Beware, if your screwdriver does not fit properly, you may damage the screws' heads.

  • If your screwdriver does not fit, or you do not have the proper one, you can use a hot glue gun to fix the screwdriver to the head of the screw. Wait for it to harden slightly, and then try to remove the screws.

Agregar Comentario

  • Remove outer case. Pull the back away from the main body of the camera.

Agregar Comentario

  • Locate the LCD screen and anchoring screw.

  • Remove screw.

Agregar Comentario

  • Carefully pull the LCD screen away from the board it is connected to.

Agregar Comentario

  • Push both blue switches away from the holding device to unleach lcd ribbon.

  • Be careful when removing ribbon. If you damage it, you will need to replace it as well.

Agregar Comentario

  • Carefully detach the ribbon from where it was connected by the blue pins.

Agregar Comentario

  • Now that everything has been disconnected from the board, remove LCD screen.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Cody

Miembro Desde 18/04/10

47 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 7-11, Maness Spring 2010 Miembro de Cal Poly, Team 7-11, Maness Spring 2010

CPSU-MANESS-S10S7G11

3 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 6

Últimos 30 Días: 10

Todo El Tiempo: 5,837