Remove the batteries from the camera to prevent danger of electric shock.
  • Remove the batteries from the camera to prevent danger of electric shock.

Agregar Comentario

Locate all five screws on the camera. Then proceed to remove all the screws.
  • Locate all five screws on the camera. Then proceed to remove all the screws.

Agregar Comentario

  • Beware, if your screwdriver does not fit properly, you may damage the screws' heads.

  • If your screwdriver does not fit, or you do not have the proper one, you can use a hot glue gun to fix the screwdriver to the head of the screw. Wait for it to harden slightly, and then try to remove the screws.

Agregar Comentario

  • Remove outer case. Pull the back away from the main body of the camera.

Agregar Comentario

  • Locate the LCD screen and anchoring screw.

  • Remove screw.

Agregar Comentario

  • Carefully pull the LCD screen away from the board it is connected to.

Agregar Comentario

  • Push both blue switches away from the holding device to unleach lcd ribbon.

  • Be careful when removing ribbon. If you damage it, you will need to replace it as well.

Agregar Comentario

  • Carefully detach the ribbon from where it was connected by the blue pins.

Agregar Comentario

  • Now that everything has been disconnected from the board, remove LCD screen.

Agregar Comentario

  • Remove the two screws holding the circuit board down.

Agregar Comentario

  • Remove black sticky tape from circuit board and camera case.

Agregar Comentario

  • Gently pull the circuit board away from the front side of the camera.

  • Be careful when removing assembly as to not break any solder leads or damage lens assembly.

Agregar Comentario

  • Remove the logic board by pulling straight away from assembly.

Agregar Comentario

  • Locate the flash unit of the camera. It includes the camera's flash and a capacitor.

Agregar Comentario

  • Unsolder the flash unit at it's three points.

  • Be careful not to damage the circuit board or surrounding parts with the solder iron.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Cody

Miembro Desde 18/04/10

47 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 7-11, Maness Spring 2010 Miembro de Cal Poly, Team 7-11, Maness Spring 2010

CPSU-MANESS-S10S7G11

3 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 5

Últimos 30 Días: 7

Todo El Tiempo: 3,623