Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Thread fishing line through all eyelets on the fishing pole.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
At the top of the allotted seven to ten feet, thread the line through one hook of the bobber by depressing the opposite side of the bobber so that the hook is exposed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Repeat step two for the opposite end of the bobber, threading the line through the second hook.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
About one to two feet before the end of the line, thread a weight onto the line.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Tie a knot around the weight's eyelet. (No specific knot needed, it just needs to stay in place.)
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
At the very end of the line, thread the line through the eyelet of the lure about 6 inches.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Twist the line around itself approximately five to six times.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Thread the remaining line through the hole created by the previous step near the lure eyelet.
-
Un comentario
This is Joe from Durban Deep Sea Fishing Charters. This is a short and concise but very helpful guide to replace a fishing line. I will be sure to share this with my clients. Thanks guys