Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Simple step-by-step instructions to replace the Refrigerator Water Filter Head & Tube Assembly WR17X12203.

  1. Disconnect the electric plug from the wall.
    • Disconnect the electric plug from the wall.

  2. Turn off or push down off water main valve from the wall.
    • Turn off or push down off water main valve from the wall.

  3. Remove the back panel with 6 screws from the back panel using a 8 mm nut driver. Remove the back panel with 6 screws from the back panel using a 8 mm nut driver. Remove the back panel with 6 screws from the back panel using a 8 mm nut driver.
    • Remove the back panel with 6 screws from the back panel using a 8 mm nut driver.

  4. El kit de herramientas esencial

    Las herramientas más útiles en nuestro kit más compacto.

    Compra ahora

    El kit de herramientas esencial

    Las herramientas más útiles en nuestro kit más compacto.

    Compra ahora
  5. Disconnect the water supplied line from the refrigerator using two  13 mm open-end wrenches. Use a little bucket to receive the water from the water lines.
    • Disconnect the water supplied line from the refrigerator using two 13 mm open-end wrenches.

    • Use a little bucket to receive the water from the water lines.

  6. Disconnect the water line from the water inlet valve using and open-end wrench size 15mm
    • Disconnect the water line from the water inlet valve using and open-end wrench size 15mm

  7. Disconnect the water line cover removing 2 screws  using a 7 mm nut driver. Pull up the gum seal compound.
    • Disconnect the water line cover removing 2 screws using a 7 mm nut driver.

    • Pull up the gum seal compound.

  8. Push the left side of the filter cover and pull it straight out.
    • Push the left side of the filter cover and pull it straight out.

  9. Remove the 2 screws  on top of the housing using  7 mm nut driver. Pull the housing and filter out slowly.
    • Remove the 2 screws on top of the housing using 7 mm nut driver.

    • Pull the housing and filter out slowly.

    • Remove the filter by turn it counterclockwise

Conclusión

To reassemble your device, follow these instructions in reverse order.

Giancarlo Marruffo

Miembro Desde 18/09/16

2 Reputación

1 Guía escrita

Equipo

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 6

Ultimos 30 días: 26

Todo El Tiempo: 834