Repara tus cosas Comunidad Tienda

Fender 65 Twin Reverb Speaker Replacement

Introducción

Speakers are the key parts within an amplifier that produce the final sound of your guitar strokes. There are two main reasons for replacing a speaker: blowing out the previous ones or upgrading for better sound and overall tone. Regardless of the reason this guide will take you through the removal and installation steps of this guide.

Qué necesitas

  1. Fender 65 Twin Reverb Speaker Replacement, Speaker: paso 1, imagen 1 de 2 Fender 65 Twin Reverb Speaker Replacement, Speaker: paso 1, imagen 2 de 2

    • Make sure to unplug the power cord!

    • Take off the back panel by unscrewing the four Phillips head screws on the back of the amplifier.

    • Keep the screws in a safe place and mark what part they are for.

    Traducir

  2. Fender 65 Twin Reverb Speaker Replacement: paso 2, imagen 1 de 2 Fender 65 Twin Reverb Speaker Replacement: paso 2, imagen 2 de 2

    • Make sure to unplug the power cord and have the amplifier turned off.

    • Unplug the audio cable running from the port labeled "INT. Speakers" to the audio speakers.

    • You should know have clean access to the speakers.

    Traducir

  4. Fender 65 Twin Reverb Speaker Replacement: paso 3, imagen 1 de 3 Fender 65 Twin Reverb Speaker Replacement: paso 3, imagen 2 de 3 Fender 65 Twin Reverb Speaker Replacement: paso 3, imagen 3 de 3

    • Locate the wire leads on the speaker that you are replacing. Notice that there are three wires and four connections.

    • Note where each wire goes. (White is positive and black is negative.

    • Remove the wires from the speaker leads.

    Traducir

  5. Fender 65 Twin Reverb Speaker Replacement: paso 4, imagen 1 de 3 Fender 65 Twin Reverb Speaker Replacement: paso 4, imagen 2 de 3 Fender 65 Twin Reverb Speaker Replacement: paso 4, imagen 3 de 3

    • Remove all the screws on the perimeter of the speaker. Use locking pliers to remove the nuts. There are eight bolts holding the speaker in place.

    • Pull the old speaker off of the board and insert the new speaker the same way you removed the old one.

    • When tightening the nuts back down on the bolts, be sure to tighten them by alternating, working in diagonals. (i.e. once you tighten one down go diagonal from it and work on the next one.

    • Repeat with the other speaker if necessary.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Documentos Adjuntos

Autor

con 3 otros colaboradores

Ryan Brown

Miembro Desde 02/20/14

210 Reputación

1 Guía escrita

Insignias: 7

+ 4 más insignias

Equipo

Cal Poly, Team 9-27, Maness Winter 2014 Miembro de Cal Poly, Team 9-27, Maness Winter 2014

CPSU-MANESS-W14S9G27

5 Miembros

7 Guías creadas

2 comentarios

Thanks for the tutorial.

csharpconsultant - Contestar

Am I missing a step here? You have the chassis in the way to access to speakers. Do u remove the chassis or do you remove the tolex with the speakers attached to it? Thanks

Albert - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 28

Todo El Tiempo: 6,329