Repara tus cosas Comunidad Tienda

Fast Fix Box Cutter Blade Replacement

Introducción

Over time your box cutter can become dull, rusted, or even break off. If this happens to you then this guide is perfect for you. Warning this replacement involves dealing with a sharp blade so be sure to use caution.

Qué necesitas

  1. Fast Fix Box Cutter Blade Replacement, Blade: paso 1, imagen 1 de 3 Fast Fix Box Cutter Blade Replacement, Blade: paso 1, imagen 2 de 3 Fast Fix Box Cutter Blade Replacement, Blade: paso 1, imagen 3 de 3

    • The case screw can easily be removed by using a Stanley #2 screwdriver or any other #2 screwdriver.

    Traducir

  2. Fast Fix Box Cutter Blade Replacement: paso 2, imagen 1 de 1

    • Separate casing by simply pulling apart both halves.

    Traducir

  3. Fast Fix Box Cutter Blade Replacement: paso 3, imagen 1 de 2 Fast Fix Box Cutter Blade Replacement: paso 3, imagen 2 de 2

    • Carefully, using the pull tab, take out the blade holder and set it on the table.

    • Remove the blade by carefully sliding it out of the holder.

    • Be very careful when dealing with the blade as it is sharp.

    Traducir

  5. Fast Fix Box Cutter Blade Replacement: paso 4, imagen 1 de 2 Fast Fix Box Cutter Blade Replacement: paso 4, imagen 2 de 2

    • Replace the old blade with the new blade by carefully sliding it into the blade holder.

    • Place the blade holder back into the casing using the pull tab to hold it.

    • Be very careful when dealing with the blade as it is sharp.

    Traducir

  6. Fast Fix Box Cutter Blade Replacement: paso 5, imagen 1 de 2 Fast Fix Box Cutter Blade Replacement: paso 5, imagen 2 de 2

    • Add grease to the sliding mechanism

    • Use either a paper towel or a cloth to spread the grease around the sliding mechanism.

    Traducir

  7. Fast Fix Box Cutter Blade Replacement: paso 6, imagen 1 de 2 Fast Fix Box Cutter Blade Replacement: paso 6, imagen 2 de 2

    • Take the other half without the blade and put it back together with the other half with the blade.

    • Snap the two parts together.

    • Place the screw back in to hole while holding the casing together.

    Traducir

  8. Fast Fix Box Cutter Blade Replacement: paso 7, imagen 1 de 2 Fast Fix Box Cutter Blade Replacement: paso 7, imagen 2 de 2

    • Use Stanley #2, or any other #2, screwdriver to screw the casing back together.

    • To ensure proper placement of the blade, activate the mechanism that slides the blade out.

    • Once it comes out, like in second picture, you are done.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 2 otros colaboradores

Peace Adeyemo

Miembro Desde 02/22/18

145 Reputación

1 Guía escrita

Insignias: 2

Equipo

University of Memphis, Team S5-G7, Baddour Spring 2018 Miembro de University of Memphis, Team S5-G7, Baddour Spring 2018

UM-BADDOUR-S18S5G7

3 Miembros

1 Guía escrita

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 22

Ultimos 30 días: 50

Todo El Tiempo: 8,905