Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Position device so that the wheels are on a firm surface .
-
Using a J1 Screwdriver bit, remove the 11 mm screw from the center of the wheel.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After removing the 11 mm screw, firmly grip the wheel and pull away from the vehicle.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
Equipo
Appalachian State University, Team S1-G4, Menagarishvili Fall 2018 Miembro de Appalachian State University, Team S1-G4, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S1G4
4 Miembros
5 Guías creadas
Un comentario
I have a question about this! I had one of these cars for my son and lost the remote so I ordered another one off ebay. The new one arrived damaged, with one of the rear wheels broken off. The black plastic part on the axle that the wheel screwed into was cracked. So I’m trying to figure out if there is a way to remove this black plastic part from the old car to put on the new one. Or if I can swap out the whole rear axle. I really am not too mechanically inclined, but I want my son to have his remote control car functioning again and I’m really trying to avoid purchasing a 3rd one. Thank you!
