Repara tus cosas Comunidad Tienda

Eureka AirSpeed Bagless Zuum Brush Roll Replacement

Introducción

If you determine that your vacuum brush roll will not turn and produces a burning smell, this guide will help you to replace the brush roll.

Qué necesitas

  1. Eureka AirSpeed Bagless Zuum Brush Roll Replacement, Brush Roll: paso 1, imagen 1 de 2 Eureka AirSpeed Bagless Zuum Brush Roll Replacement, Brush Roll: paso 1, imagen 2 de 2

    • Step on the grey release button located between the two back wheels to lower the handle flat to the floor.

    • Insure the vacuum is unplugged before starting the process of removing the brush roll.

    Editar

  2. Eureka AirSpeed Bagless Zuum Brush Roll Replacement: paso 2, imagen 1 de 1

    • Using a Phillips #2 screwdriver, remove the four screws from each corner of the brush roll cover.

    Editar

  4. Eureka AirSpeed Bagless Zuum Brush Roll Replacement: paso 3, imagen 1 de 2 Eureka AirSpeed Bagless Zuum Brush Roll Replacement: paso 3, imagen 2 de 2

    • Remove the brush cover from the vacuum base, by pulling straight up.

    Editar

  5. Eureka AirSpeed Bagless Zuum Brush Roll Replacement: paso 4, imagen 1 de 1

    • Firmly press upwards from below the brush roll on the side opposite the belt.

    Editar

  6. Eureka AirSpeed Bagless Zuum Brush Roll Replacement: paso 5, imagen 1 de 1

    • After one end is displaced, remove the other side by pressing firmly upwards from below the the brush roll.

    Editar

  7. Eureka AirSpeed Bagless Zuum Brush Roll Replacement: paso 6, imagen 1 de 1

    • Once the brush roll is displaced from the base, detach the belt from the brush roll in order to clean the brush roll.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

6 personas más completaron esta guía.

Autor

con 7 otros colaboradores

Celina Burchett

Miembro Desde 10/13/14

1,122 Reputación

8 Guías creadas

Insignias: 13

+ 10 más insignias

Equipo

Clemson, Team 2-2, Benson Fall 2014 Miembro de Clemson, Team 2-2, Benson Fall 2014

CLEM-BENSON-F14S2G2

4 Miembros

18 Guías creadas

Un comentario

Brush roll replacement is a no brainer. It is the brush roll assembly that turns the brush that I need to fix. Cannot determine what tool to use as it doesn't come off using a regular screwdriver and eureka won't tell me what to ese.

Tami Jones - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 4

Ultimos 30 días: 21

Todo El Tiempo: 12,028