Menú

Tus configuraciones

Mi Mesa de Trabajo

Obtén acceso rápido a guías, partes y respuestas para tus dispositivos
Mi Carrito

Al parecer tu carrito está vacío

Visita Nuestra Tienda

Eureka 1660SP Extendable Pole Realignment

Escrito Por: Evan Fodi (y 5 de otros participantes)
  • Comentarios: 0
  • Favoritos: 1
  • Terminaciones: 1

Dificultad

Moderar

Pasos

5

Tiempo Requerido

15 minutos

Secciones

2

Banderas

1

Better Introduction

Mejor introducción

Mejora esta guía completando o revisando su introducción.

Herramientas

Comprar estas herramientas

Partes

No se especificaron partes.

  1. Make sure that your vacuum is unplugged from a power source. Press the black button just below the handle and extend the pole fully.

    • Make sure that your vacuum is unplugged from a power source.

    • Press the black button just below the handle and extend the pole fully.

    Traducir

  2. Press the black separator switch to separate the top and bottom halves of the vacuum. Press the black separator switch to separate the top and bottom halves of the vacuum.

    • Press the black separator switch to separate the top and bottom halves of the vacuum.

    Traducir

  3. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

  4. Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown. Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing. Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

    • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

    Traducir

  5. Once the housing is open, locate the solid chrome plated piece at the front end of the extendable pole.

    • Once the housing is open, locate the solid chrome plated piece at the front end of the extendable pole.

    Traducir

  6. On the side of the motor housing which does not hold the engine, find the center track which runs along the inside of the housing. Re-insert the chrome plated piece into the center track.

    • On the side of the motor housing which does not hold the engine, find the center track which runs along the inside of the housing.

    • Re-insert the chrome plated piece into the center track.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 Comentarios

Agregar un comentario

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 291