Etekcity Lasergrip 1080 Laser Replacement

Introducción

This will teach you to uninstall and reinstall a laser from the motherboard. This is needed if the laser stops working and cannot be turned on by pressing the button to do so. The tools required will be a screwdriver and a soldering iron. The soldering iron is hot and may cause a potential hazard. For those who are uncomfortable soldering, there is a link to a soldering guide in the Troubleshooting section of the device page.

Qué necesitas

Paso 1 Battery

Etekcity Lasergrip 1080 Laser Replacement, Battery: paso 1, imagen 1 de 1

Pull the battery cover away from the handle by gripping near the thumb groove.

Editar

Paso 2

Gently pull the battery out of the handle.
Excessive force could damage wires.

Editar

Paso 3

Disconnect the battery by pulling the connector away from it.
Positive first
Negative second
When replacing the battery, this order is reversed.

Editar

Paso 4 Buttons

Etekcity Lasergrip 1080 Laser Replacement, Buttons: paso 4, imagen 1 de 2

Etekcity Lasergrip 1080 Laser Replacement, Buttons: paso 4, imagen 2 de 2

Remove the battery cover from the device by pulling it straight out.

Editar

Paso 5

Using the plastic opening tool remove the front and rear yellow covers.
When removing the back cover, be careful not to lose the buttons as they are not connected.

Editar

Paso 6

Remove the two 3.1 mm Phillips #0 screws.

Editar

Paso 7

Pull the two halves apart.
Be careful not to lose any components on the inside.

Editar

Paso 8

Realign the buttons with the button terminals.
Red terminal to red button.
Orange terminal to orange button.
Yellow terminal to yellow button.

Editar

Paso 9 Etekcity Lasergrip 1080 Trigger Replacement

Etekcity Lasergrip 1080 Laser Replacement, Etekcity Lasergrip 1080 Trigger Replacement: paso 9, imagen 1 de 2

Etekcity Lasergrip 1080 Laser Replacement, Etekcity Lasergrip 1080 Trigger Replacement: paso 9, imagen 2 de 2

Carefully pull the trigger out.
The trigger is spring loaded, so be careful that you do not lose the spring as you pull the trigger out.
To put the trigger back in, align the peg with the hole in the handle and align the shaft with the button terminal.

Editar

Paso 10 Laser

Etekcity Lasergrip 1080 Laser Replacement, Laser: paso 10, imagen 1 de 1

Pull the motherboard out of its slot in the device.

Editar

Paso 11

Use a soldering iron to melt the solder that holds the wires for the laser to the motherboard.
Soldering irons are hot and should only be handled by those who know what they are doing and are wearing proper safety equipment. There is a link to a soldering guide in the Troubleshooting section of the device page.

Editar