Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 1.2 mm Phillips #1 screws on the back of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pry off the back panel of the radar using the nylon spudger.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully pry the grey frame off the black plastic covering using the nylon spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the orange flap from the motherboard using a nylon spudger.
-
Carefully remove the motherboard from the grey plastic frame.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the remaining two orange flaps from the circuit board that is attached onto the grey frame.
-