Introducción

To keep your device protected, make sure that the back panel of your device is crack free. If your radar's back panel has a really bad crack, follow these steps to replace it.

Partes

No se requieren partes.

  1. Remove the three 1.2 mm Phillips #1 screws on the back of the device.
    • Remove the three 1.2 mm Phillips #1 screws on the back of the device.

  2. Pry off the back panel of the radar using the nylon spudger.
    • Pry off the back panel of the radar using the nylon spudger.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Kennedy Morales

Miembro Desde 20/10/17

626 Reputación

6 Guías creadas

Equipo

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 29

Todo El Tiempo: 45