Epson Stylus NX305 Scanner Motor Replacement

Introducción

The scanner motor is what moves the scanning mechanism allowing it to scan and copy documents. This motor may stop working causing the scanning mechanism not to move, which would not allow you to scan or copy. In this case the scanner motor would need to be replaced.

Qué necesitas

Paso 1 Scanner Motor

Epson Stylus NX305 Scanner Motor Replacement, Scanner Motor: paso 1, imagen 1 de 1

Make sure that the printer is not plugged in before working on it.
Orient the printer so that the back of it is facing you.

Traducir

Paso 2

Locate the 3mm Phillips #0 screw that is on the right-hand side of the printer.
Using a Phillips head screwdriver, remove the screw.

Traducir

Paso 3

Open up the lid of the printer.
With the printer facing away from you, lift up on the right hand side of the lid of the printer and slide it to the left to remove it.
Be careful not to remove the white ribbon and wires that are connected.

Traducir

Paso 4

With the printer facing you, open the lid of the scanner to expose the 3mm Phillips #0 screw at the top left of the scanner.
Using a Phillips head screwdriver, remove the screw.

Traducir

Paso 5

Locate the six 3mm Phillips #2 screws under the lid of the printer and remove them.

Traducir

Paso 6

Locate the three clips on the front side of the printer lid.
Use the plastic opening tool to release the clips and carefully pry open the lid.

Traducir

Paso 7

Locate the belt that is attached to the scanner motor and remove it by carefully stretching off of the gear.

Traducir

Paso 8

Remove the two 3mm Phillips #2 screws from the scanner motor assembly.
Carefully lift the scanner motor assembly out of the housing making sure not to damage the wiring.

Traducir