Saltar al contenido principal

EVGA x17 Clicker Replacement

Qué necesitas

  1. EVGA x17 Clicker Replacement, Clicker: paso 1, imagen 1 de 1
    • Remove the mouse skates to reveal 5 screws.

  2. EVGA x17 Clicker Replacement: paso 2, imagen 1 de 1
    • Use a Phillips head screwdriver to remove the 5 screws that secure the bottom panel.

  3. EVGA x17 Clicker Replacement: paso 3, imagen 1 de 1
    • Remove the weight chamber cover.

  4. EVGA x17 Clicker Replacement: paso 4, imagen 1 de 1
    • Slowly slide a spudger into and around the bottom of the panel, prying until a "popping" sound is heard.

  5. EVGA x17 Clicker Replacement: paso 5, imagen 1 de 2 EVGA x17 Clicker Replacement: paso 5, imagen 2 de 2
    • Remove the 13 screws on the interior.

    • There are 2 Phillips truss-head tapping screws, large circular heads, and the 11 Phillips screws from the interior.

  6. EVGA x17 Clicker Replacement: paso 6, imagen 1 de 1
    • Carefully slide the middle section out.

  7. EVGA x17 Clicker Replacement: paso 7, imagen 1 de 1
    • Remove the two screws from each clicker.

  8. EVGA x17 Clicker Replacement: paso 8, imagen 1 de 1
    • Pop and slide out each clicker that needs to be replaced.

    • Clickers may need to be tugged forward in their slots to slide out.

    • Be extra careful removing clickers because the attachments are fragile.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Un comentario

Tengo un Evga x17 y cuando quitó los sliders, encuentro unas pequeñas capas de plástico que tapan el acceso a los tornillos, ¿qué puedo hacer en ese caso?

Dennis Lopez - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 19

Todo El Tiempo: 133