Repara tus cosas Comunidad Tienda

Dyson DC56 Cyclone Replacement

Introducción

The cyclone is a method of separating particles from the air within the vacuum. If something goes wrong with the cyclone it could cause issues with suction or even prevent the vacuum from working at all.

Qué necesitas

  1. Dyson DC56 Cyclone Replacement, Dust Bin: paso 1, imagen 1 de 1

    • Make sure the vacuum is unplugged.

    • Warning: Avoid pressing the red trigger because it will turn on and begin suction.

    Editar

  2. Dyson DC56 Cyclone Replacement: paso 2, imagen 1 de 1

    • Locate the purple button at the top of the device.

    Editar

  3. Dyson DC56 Cyclone Replacement: paso 3, imagen 1 de 1

    • Separate the device with the purple button.

    Editar

  4. Dyson DC56 Cyclone Replacement: paso 4, imagen 1 de 1

    • Locate the dust bin's red release lever on the side of the device.

    • Make sure if the dust bin is full you open the vacuum over a trash can.

    Editar

  6. Dyson DC56 Cyclone Replacement: paso 5, imagen 1 de 1

    • Push the red lever to release the dust bin lid.

    Editar

  7. Dyson DC56 Cyclone Replacement: paso 6, imagen 1 de 1

    • Locate the red lever below the vacuum.

    Editar

  8. Dyson DC56 Cyclone Replacement: paso 7, imagen 1 de 1

    • Push the red lever, pull the back up and away from the dust bin to separate them.

    Editar

  9. Dyson DC56 Cyclone Replacement, Cyclone: paso 8, imagen 1 de 1

    • Use a T8-Torque screwdriver to remove the 18mm screw from the back of the Cyclone.

    Editar

  10. Dyson DC56 Cyclone Replacement: paso 9, imagen 1 de 1

    • Remove the bottom of the cyclone screen by twisting it to the left and pulling down.

    Editar

  11. Dyson DC56 Cyclone Replacement: paso 10, imagen 1 de 1

    • Remove the rest of the cyclone screen by pulling down.

    Editar

  12. Dyson DC56 Cyclone Replacement: paso 11, imagen 1 de 1

    • Locate and take out the six 26mm screws with a T-8 Torque screwdriver.

    • Once you have removed the screws you can remove the rest of the Cyclone.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 4 otros colaboradores

John Czerkawski

Miembro Desde 10/02/17

427 Reputación

4 Guías creadas

Insignias: 7

+ 4 más insignias

Equipo

USF Tampa, Team S10-G1, Thompson Fall 2017 Miembro de USF Tampa, Team S10-G1, Thompson Fall 2017

USFT-THOMPSON-F17S10G1

4 Miembros

11 Guías creadas

Un comentario

I can’t remove the cyclone screen. Any tricks to removing?

J M - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 3

Ultimos 30 días: 6

Todo El Tiempo: 943