Repara tus cosas Comunidad Tienda

Durofix RV332 Battery LED Replacement

Introducción

Use this guide to replace a defective battery LED indicator from your Durofix RV332. A new battery LED is need to complete this repair.

Qué necesitas

  1. Durofix RV332 Battery LED Replacement, Battery LED: paso 1, imagen 1 de 1

    • Remove the six 13 mm case screws with a #0 Phillips screwdriver from the side of the power screwdriver.

    Editar

  2. Durofix RV332 Battery LED Replacement: paso 2, imagen 1 de 2 Durofix RV332 Battery LED Replacement: paso 2, imagen 2 de 2

    • Using a plastic opening tool, separate the case in two to expose the internals of the cordless screwdriver.

    Editar

  4. Durofix RV332 Battery LED Replacement: paso 3, imagen 1 de 3 Durofix RV332 Battery LED Replacement: paso 3, imagen 2 de 3 Durofix RV332 Battery LED Replacement: paso 3, imagen 3 de 3

    • Remove printed circuit board, LED, battery, and motor assembly from the screwdriver casing.

    • Use a soldering iron to melt the solder from the LED's two pins on the printed circuit board.

    • Remove the LED from the circuit board while the solder is still melted.

    Editar

  5. Durofix RV332 Battery LED Replacement: paso 4, imagen 1 de 2 Durofix RV332 Battery LED Replacement: paso 4, imagen 2 de 2

    • Place the positive leg of the new LED through the positive hole in the printed circuit board and solder it into place.

    • Place the negative leg of the LED through the negative hold in the printed circuit board and solder it into place.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 5 otros colaboradores

Tyler Vincent

Miembro Desde 02/24/14

479 Reputación

4 Guías creadas

Insignias: 9

+ 6 más insignias

Equipo

Michigan Tech, Team 5-5, Lauer Spring 2014 Miembro de Michigan Tech, Team 5-5, Lauer Spring 2014

MTU-LAUER-S14S5G5

3 Miembros

5 Guías creadas

Un comentario

Hello, I would ask the author about the type and model number of the electronic element marked as Q1 on the PCB (transistor or thyristor) on the third picture in Step 3 of this article, because mine is burnt out, and on this picture can't be read anything.

Greetings,

Plam

Пламен Петракиев - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 2

Ultimos 30 días: 4

Todo El Tiempo: 1,090