Saltar al contenido principal

Introducción

This guide is to replace a damaged battery on the Motorola Droid XT 1080. It is important because your phone will not charge or turn on if the battery needs to be replaced.

  1. Remove the SIM card tray from the side of the device using a plastic opening tool.
    • Remove the SIM card tray from the side of the device using a plastic opening tool.

  2. After properly removing the SIM card tray take your spudger and press it in between the plastic case and the frame of the device until you hear a snap.
    • After properly removing the SIM card tray take your spudger and press it in between the plastic case and the frame of the device until you hear a snap.

    • Work your way from the top and the other side to confirm all the clips are disconnected.

    • Be gentle when performing this so you don't crack or break the plastic.

  3. Remove the five screws on top of the device with a T5 Torx.
    • Remove the five screws on top of the device with a T5 Torx.

    • Remove the single screw holding the camera with a T4 Torx.

    • Remove the two screws on the bottom of the device with a T5 Torx.

  4. Kits de Reparación de Android

    A new screen or battery is one kit away.

    Comprar Ahora

    Kits de Reparación de Android

    A new screen or battery is one kit away.

    Comprar Ahora
  5. After the top and bottom screws are removed remove the top and bottom plastic pieces that were secured to the device. After the top and bottom screws are removed remove the top and bottom plastic pieces that were secured to the device.
    • After the top and bottom screws are removed remove the top and bottom plastic pieces that were secured to the device.

  6. Begin to gently pry up the battery from the frame with a plastic opening tool to release it from its adhesive securing.
    • Begin to gently pry up the battery from the frame with a plastic opening tool to release it from its adhesive securing.

  7. Remove the four T5 Torx screws securing the motherboard.
    • Remove the four T5 Torx screws securing the motherboard.

  8. Gently pry the motherboard out of the frame using the nylon spudger. Make sure not to damage the LCD cable in the process.
    • Gently pry the motherboard out of the frame using the nylon spudger.

    • Make sure not to damage the LCD cable in the process.

  9. Disconnect the LCD cable with a spudger from the motherboard by gently lifting up the two connectors.
    • Disconnect the LCD cable with a spudger from the motherboard by gently lifting up the two connectors.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

knoyes

Miembro Desde 30/10/18

754 Reputación

5 Guías creadas

Equipo

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 10

Últimos 30 Días: 64

Todo El Tiempo: 934