Saltar al contenido principal

Introducción

If one of the tail lights in your 2004 Dodge Durango is not lighting up, you may need to replace the bulb inside. A faulty bulb may result in a costly fine or an accident on the road, as tail lights are essential for signaling other vehicles. Before trying this guide, first check if the car’s battery is fully charged and functional.

Make sure the car’s engine is off, the parking brake is engaged, and the battery is disconnected before beginning this guide.

  1. Dodge Durango 2004 Tail Light Bulb Replacement, Dodge Durango 2004 Tail Light Bulb: paso 1, imagen 1 de 2 Dodge Durango 2004 Tail Light Bulb Replacement, Dodge Durango 2004 Tail Light Bulb: paso 1, imagen 2 de 2
    • Open the car's trunk.

  2. Dodge Durango 2004 Tail Light Bulb Replacement: paso 2, imagen 1 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 2, imagen 2 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 2, imagen 3 de 3
    • Pry both caps out using a spudger.

  3. Dodge Durango 2004 Tail Light Bulb Replacement: paso 3, imagen 1 de 1
    • Carefully pull the tail light towards yourself to gain access to the wiring.

    • Do not pull the tail light too far. It is still connected to the wires and moving it too far may damage them.

  4. Dodge Durango 2004 Tail Light Bulb Replacement: paso 4, imagen 1 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 4, imagen 2 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 4, imagen 3 de 3
    • Locate the connector and pull the orange safety pin out.

    • After the safety pin is out, pull on the connector plug to separate it from the tail light.

  5. Dodge Durango 2004 Tail Light Bulb Replacement: paso 5, imagen 1 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 5, imagen 2 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 5, imagen 3 de 3
    • Remove the three Torx 15 screws that are holding the bulb carrier in place.

  6. Dodge Durango 2004 Tail Light Bulb Replacement: paso 6, imagen 1 de 2 Dodge Durango 2004 Tail Light Bulb Replacement: paso 6, imagen 2 de 2
    • Remove the bulb holder piece from the tail light by gently pulling it up.

  7. Dodge Durango 2004 Tail Light Bulb Replacement: paso 7, imagen 1 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 7, imagen 2 de 3 Dodge Durango 2004 Tail Light Bulb Replacement: paso 7, imagen 3 de 3
    • Remove the defective bulb by pulling it up.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 6

Ultimos 30 días: 41

Todo El Tiempo: 249