Repara tus cosas Comunidad Tienda

Disassembling Sony Reader Touch Edition PRS-600 Inner Casing

Qué necesitas

  1. Disassembling Sony Reader Touch Edition PRS-600 Inner Casing, Back Panel: paso 1, imagen 1 de 1

    • Using the Phillips head screwdriver PH000, remove the two 1.4 mm screws that are located on the backside of the device.

    Editar

  2. Disassembling Sony Reader Touch Edition PRS-600 Inner Casing: paso 2, imagen 1 de 1

    • Slide the back cover off by pushing it to the left, away from the side that held the screws.

    • Remove the cover.

    Editar

  3. Disassembling Sony Reader Touch Edition PRS-600 Inner Casing: paso 3, imagen 1 de 1

    • This is what the device should look like once the back cover panel has been removed.

    Editar

  5. Disassembling Sony Reader Touch Edition PRS-600 Inner Casing, Battery: paso 4, imagen 1 de 1

    • Once the back cover has been removed locate the battery in the bottom right corner of the device.

    • Using the pointed end of the spudger, push out the white plug that is connected to the battery from its beige base.

    Editar

  6. Disassembling Sony Reader Touch Edition PRS-600 Inner Casing: paso 5, imagen 1 de 1

    • Use the flat end of the spudger to pry the battery out of its holder. There may be glue holding it in place.

    Editar

  7. Disassembling Sony Reader Touch Edition PRS-600 Inner Casing, Inner Casing: paso 6, imagen 1 de 1

    • Using a screwdriver remove the four 1.4 mm screws that are holding the black plastic casing in place.

    Editar

  8. Disassembling Sony Reader Touch Edition PRS-600 Inner Casing: paso 7, imagen 1 de 1

    • Pry open the black casing to access the screw that is holding down the battery holder.

    • Remove the one 1.4 mm screw that is holding down the battery holder located under black casing.

    • Lift the black inner casing and the battery holder out of the device.

    • The battery holder and the black inner casing are connected by a thin strip of copper. There may be glue holding the black inner casing in place.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 3 otros colaboradores

Terrika Ngobili

Miembro Desde 10/13/14

857 Reputación

7 Guías creadas

Insignias: 11

+ 8 más insignias

Equipo

Clemson, Team 1-4, Benson Fall 2014 Miembro de Clemson, Team 1-4, Benson Fall 2014

CLEM-BENSON-F14S1G4

4 Miembros

22 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 3

Ultimos 30 días: 5

Todo El Tiempo: 762