Disassembling Sony Ericsson QuickShare T630 Phone Enclosure - Guía de reparación iFixit

Introducción

This guide acts as a prerequisite for the guides following it. This will show you how to disassemble to phone enclosure in order to access the internal components of the device.

Qué necesitas

Paso 1 Sony Ericsson QuickShare T630 Phone Enclosure

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure, Sony Ericsson QuickShare T630 Phone Enclosure: paso 1, imagen 1 de 1

Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

Paso 2

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 2, imagen 1 de 2

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 2, imagen 2 de 2

Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

Paso 3

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 3, imagen 1 de 1

Slide the battery upward to remove.

Paso 4

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 4, imagen 1 de 2

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 4, imagen 2 de 2

Remove the rubber plug located near the camera by gently prying upward with your fingers.
Gently lift the camera shield after removal of the rubber plug.

Paso 5

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 5, imagen 1 de 2

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 5, imagen 2 de 2

Pry the remaining panel to loosen its contact to the phone using a spudger.
Slide the panel upward to remove it completely.
These steps will require a slight appliance of force.

Paso 6

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 6, imagen 1 de 1

Slide the aerial upward to remove it.

Paso 7

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 7, imagen 1 de 2

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 7, imagen 2 de 2

Remove the four screws located at each corner of the device.

Paso 8

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 8, imagen 1 de 2

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 8, imagen 2 de 2

Gently lift and remove the front panel of the phone after removing the screws.

Paso 9

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 9, imagen 1 de 3

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 9, imagen 2 de 3

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 9, imagen 3 de 3

This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.
Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.
Gently pull the ribbon from the circuit.
Remove the now disconnected screen.

Paso 10

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 10, imagen 1 de 3

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 10, imagen 2 de 3

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: paso 10, imagen 3 de 3

Remove the keyboard by slowly pulling it away from the circuit board.
There are no direct connections between the keyboard and phone.
These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 7 otros colaboradores

Christine Becker

Miembro Desde 10/28/13

101 Reputación

1 Guía escrita

+1 mas insignia

Equipo

University of Maine, Team 1-13, Diaz Fall 2013 Miembro de University of Maine, Team 1-13, Diaz Fall 2013

UMAINE-DIAZ-F13S1G13

3 Miembros

14 Guías creadas

0 comentarios

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 11

Ultimos 30 días: 22

Todo El Tiempo: 3,529