Introducción

Before the display and camera housing can be repaired or replaced they must first be separated. This guide will detail how to prepare the display and camera for separation.

Partes

No se requieren partes.

  1. Begin by placing the camera upside down and removing the three small center screws.
    • Begin by placing the camera upside down and removing the three small center screws.

    • All screws are the same size and length and can be used interchangably.

    Agregar Comentario

  2. Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel.
    • Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel.

    • Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Locate the camera's tripod mount located on the bottom of the camera.

    • Carefully remove the camera's tripod mount and place it aside.

    • Be careful not to lose this piece.

    • Rotate the silver panel labeled 4x clockwise.

    Agregar Comentario

    • Align the camera so that the side with "4x Optical Zoom" is facing toward you.

    • Gently twist the bottom corner clockwise until you feel the side panel unlock.

    • Lift off the side panel and set aside.

    Agregar Comentario

    • Rotate the camera 180 degrees to face the side panel with the lanyard loop on it.

    • Gently lift the panel vertically until it lifts off

    • Take care to not lose the small rectangular portion on the bottom of the panel.

    Agregar Comentario

    • Position the camera so the bottom is facing up and the display away from the surface.

    • Gently pry the screen portion from the camera portion with your fingers or a plastic prybar.

    • Do not fully separate the two components! the screen is attached by two ribbon cables.

    • Lay the display flat to expose the circuit board and the display control ribbon cables.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Steve Van Hall

Miembro Desde 09/03/12

27 Reputación

2 Guías creadas

Equipo

Clemson, Team 2-3, Benson Spring 2012 Miembro de Clemson, Team 2-3, Benson Spring 2012

CLEM-BENSON-S12S2G3

3 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 3

Todo El Tiempo: 1,402