Introducción

This guide will instruct you to take the left cover off of the camcorder.

  1. Remove the 6-7.9mm ph#0 screws on the back and bottom. Remove the one 3.8mm ph#0 screw on the bottom.
    • Remove the 6-7.9mm ph#0 screws on the back and bottom.

    • Remove the one 3.8mm ph#0 screw on the bottom.

    • Remove the two 7.5mm ph#0 screws on the back and bottom.

  2. Remove 5.8mm ph#1 screw from the side button panel. Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.
    • Remove 5.8mm ph#1 screw from the side button panel.

    • Slide the viewfinder all the way to the right and remove the 7.9mm ph#0 screw.

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda

    ¿Alguna vez arreglaste algo? Eso es genial.

    Comparte tu historia de reparación con #SoyUnGenio

    Todos somos Genios

    Comparte tu historia de reparación con #SoyUnGenio

  4. Pry along the seam on the top side near the buttons with a spudger. Pry along the seam on the top side near the buttons with a spudger.
    • Pry along the seam on the top side near the buttons with a spudger.

  5. Pull the left panel away from the rest of the camcorder. Unplug the red speaker cable located at the rear of the device.
    • Pull the left panel away from the rest of the camcorder.

    • Unplug the red speaker cable located at the rear of the device.

    • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Cal Poly, Team 5-20, Amido Winter 2011 Miembro de Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 Miembros

7 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 4

Todo El Tiempo: 601