Remove the four rubber screw covers from encircled locations.
  • Remove the four rubber screw covers from encircled locations.

  • Using a #0 tri wing screwdriver, remove the screws previously hidden below the rubber covers.

  • If you have difficulties finding this screwdriver, it is commonly sold as a Nintendo Gameboy/Wii screwdriver.

Agregar Comentario

Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.
  • Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.

  • Be mindful of location and magnitude of applied force, so as not to damage the case.

Agregar Comentario

Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.
  • Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.

Agregar Comentario

Use fingernails to pry off minor LCD mount, as shown.
  • Use fingernails to pry off minor LCD mount, as shown.

  • Remove the minor LCD

Agregar Comentario

Unlock the LCD main board connectors shown in red boxes on the picture .
  • Unlock the LCD main board connectors shown in red boxes on the picture .

  • Use tweezers as necessary.

Agregar Comentario

Place finger nails on the connector tab as shown.
  • Place finger nails on the connector tab as shown.

  • Lift the connector tab up.

Agregar Comentario

Pull/pivot the LCD main board as shown in order to remove.
  • Pull/pivot the LCD main board as shown in order to remove.

Agregar Comentario

Use a tweezers to lift up the main LCD
  • Use a tweezers to lift up the main LCD

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Van

Miembro Desde 24/06/10

7 Reputación

16 Guías creadas

Equipo

Cal Poly, Team 2-10, Johann Summer 2010 Miembro de Cal Poly, Team 2-10, Johann Summer 2010

CPSU-JOHANN-R10S2G10

4 Miembros

20 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 1

Todo El Tiempo: 1,135