Repara tus cosas Comunidad Tienda

Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case

Introducción

With this guide you can take your MM-4 from one solid brick of a speaker to four parts and a bunch of screws. This is useful if you are replacing a bad driver, or if the connector becomes damaged and you need to replace it.

Qué necesitas

  1. Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case, Case: paso 1, imagen 1 de 2 Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case, Case: paso 1, imagen 2 de 2

    • Turn the speaker face down, so the connector side is up.

    • Remove the four #2 Philips screws on the back plate.

    Editar

  2. Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case: paso 2, imagen 1 de 1

    • Remove the foam insert to expose the two spade connectors.

    • Carefully separate the connectors

    Editar

  4. Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case: paso 3, imagen 1 de 2 Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case: paso 3, imagen 2 de 2

    • Turn the speaker so the grill side is up.

    • Remove the four screws on the grill. I had to use a t-10 Torx bit to remove them.

    • The grill is not glued on, but may require a bit of prying to remove.

    Editar

  5. Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case: paso 4, imagen 1 de 2 Disassembling Meyer Sound MM-4 Ultra Compact Wide-Range Loudspeaker Case: paso 4, imagen 2 de 2

    • Remove the four silver bolts holding the speaker in place. These bolts also have threads inset for the grill screws to fit into.

    • This is a pretty quick and easy teardown, not too many parts in this one. The meyer speaker's part number is ST-164. It's a 16 Ohm driver.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Autor

RoggeSound

Miembro Desde 06/05/10

2,342 Reputación

1 Guía escrita

Insignias: 25

+ 22 más insignias

2 comentarios

So I took one of my MM-4 apart because something was rattling. Turns out it has a loose magnet assembly. It must have been dropped in shipping.

Garrett McWilliams - Contestar

Do you by any chance still have it?

I have two of them already and with some zipties and rubber they sound great again…

Would you by any chance ship the broken driver over to me?

Jan Marius -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 11

Todo El Tiempo: 6,749