Disassembling Compaq Mini 110 Screen

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

Maybe it's cracked. Maybe you brought a magnet too close to it. Either way, the screen needs replacing and here's how to do it.

Qué necesitas

Paso 1 Battery

Disassembling Compaq Mini 110 Screen, Battery: paso 1, imagen 1 de 2

Disassembling Compaq Mini 110 Screen, Battery: paso 1, imagen 2 de 2

Locate the battery and the battery tabs on the bottom of the Compaq Mini.

Traducir

Paso 2

Disassembling Compaq Mini 110 Screen: paso 2, imagen 3 de 3

Push both tabs inward simultaneously and slide the battery out.

Traducir

Paso 3 RAM

Disassembling Compaq Mini 110 Screen, RAM: paso 3, imagen 1 de 2

Disassembling Compaq Mini 110 Screen, RAM: paso 3, imagen 2 de 2

Use a Philips #0 screwdriver to unscrew the two screws covering the memory compartment on the bottom of the laptop and remove the cover.

Traducir

Paso 4

Push out the side tabs simultaneously and pull out the old RAM module.
When inserting a new RAM stick, be sure to evenly insert the gold pins in the same orientation that the old module was removed. While sliding the module in, press the side tabs in place.

Traducir

Paso 5 Keyboard

Disassembling Compaq Mini 110 Screen, Keyboard: paso 5, imagen 1 de 2

Disassembling Compaq Mini 110 Screen, Keyboard: paso 5, imagen 2 de 2

Remove the rubber pads located on the corners of your Compaq Mini.
There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Traducir

Paso 6

Unscrew all the corner screws. There are four total, one under each rubber pad.

Traducir

Paso 7

Unscrew the screw for the bottom case located in the RAM compartment.

Traducir

Paso 8

Remove the three screws in the silver tabs at the back of the keyboard.
These are located at the back of the base under the screen.
Lift the keyboard away from the laptop.

Traducir

Paso 9 Hard Drive

Disassembling Compaq Mini 110 Screen, Hard Drive: paso 9, imagen 1 de 1

Remove the three screws holding the panel in place.

Traducir

Paso 10

Pull up on the tab to remove the hard drive.

Traducir

Paso 11 Top Cover

Disassembling Compaq Mini 110 Screen, Top Cover: paso 11, imagen 1 de 1

Remove the eight screws that are from the plastic top cover.

Traducir

Paso 12

Disassembling Compaq Mini 110 Screen: paso 12, imagen 3 de 3

Pry up the top plastic cover using a spudger.
These two tabs under the screen need to be pushed in with a spudger.

Traducir

Paso 13

Remove the cable by carefully pulling it up.
Be careful when lifting up the cover because the track pad is still attached.

Traducir

Paso 14 Display Assembly

Disassembling Compaq Mini 110 Screen, Display Assembly: paso 14, imagen 1 de 3

Disassembling Compaq Mini 110 Screen, Display Assembly: paso 14, imagen 2 de 3

Disassembling Compaq Mini 110 Screen, Display Assembly: paso 14, imagen 3 de 3

Remove the four screws that keep the bottom of the hinges attached to the base.

Traducir

Paso 15

Disassembling Compaq Mini 110 Screen: paso 15, imagen 3 de 3

Pry off the top plastic cover of the display assembly.
The spudger may go all the way through to the screen-side of the cover. This is not a problem and won't damage anything.
There is adhesive tape holding the cover on.

Traducir

Paso 16 Screen

Disassembling Compaq Mini 110 Screen, Screen: paso 16, imagen 1 de 3

Disassembling Compaq Mini 110 Screen, Screen: paso 16, imagen 2 de 3

Disassembling Compaq Mini 110 Screen, Screen: paso 16, imagen 3 de 3

Remove the 4 screws keeping the screen on the plastic assembly.

Traducir

Paso 17

Disassembling Compaq Mini 110 Screen: paso 17, imagen 3 de 3

Take the screen off the metal connectors by unscrewing each side. Each side has 2 screws
The last picture is of the metal connectors that attach it to the display assembly.

Traducir

Paso 18

Disassembling Compaq Mini 110 Screen: paso 18, imagen 3 de 3

The huge wire on the back of the screen is for both the webcam/microphone, as well as the screen.
Detach the cable from the screen. It is connected under the foil flap.

Traducir