Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Introducción

This is the most important step. You will not be able to proceed to any other guides until you successfully open the case. Be sure to layout your magnetic project mat to lay your screws as you remove them and be extra cautious of the sharp edges after you remove the case.

  1. Remove the two rubber feet on the motor side of the device. Remove the five Phillips screws from the bottom of the case.
    • Remove the two rubber feet on the motor side of the device.

    • Remove the five Phillips screws from the bottom of the case.

    • These screws are recessed deep in the device, so a long, thin screwdriver is required.

  2. Remove the two hex-cap screws on the bottom using a pair of pliers.
    • Remove the two hex-cap screws on the bottom using a pair of pliers.

  3. Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch

    Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch
  4. Carefully flip the device right-side-up while grasping the top and bottom pieces.
    • Carefully flip the device right-side-up while grasping the top and bottom pieces.

    • The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

  5. Remove the sharpener guard by gently pulling up on it.
    • Remove the sharpener guard by gently pulling up on it.

    • If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Equipo

IUPUI, Team 3-3, Harley Fall 2015 Miembro de IUPUI, Team 3-3, Harley Fall 2015

IUPUI-HARLEY-F15S3G3

5 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 5

Ultimos 30 días: 14

Todo El Tiempo: 620