Introducción

The flash device has a couple of delicate connections and should be handled with care.

Partes

No se requieren partes.

  1. Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.
    • Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.

    • Remove the 2 screws(4.08mm) on the other side. One is located under the rubber USB flap.

    • Remove the last screw(2.59mm) located on the bottom of the camera.

    • Slowly pull the back cover of the camera.

  2. Remove the screw(2.59mm) from the bottom of the camera.
    • Remove the screw(2.59mm) from the bottom of the camera.

    • Remove the screw(4.08mm) from the menu button side of the camera.

    • The 2 screws on the other side of the camera were already removed when taking off the back cover.

    • Unplug the green (if color-blind please ask someone for assistance) and white plugs connecting the top panel to top of the logic board.

    • Dislodge the tab above the lens.

    • Dislodge the back tab.

    • Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen.

    • Disconnect the ribbons connecting the screen to the camera.

    • Remove the screen by lifting it off.

    • CAUTION WHEN REMOVING FLASH. BE CAREFUL,THE CAPACITOR MAY STILL HAVE A CHARGE AND COULD SHOCK YOU.

    • Remove 2 screws(1.75mm) from the back with screwdriver, disconnecting the metal guard.

    • On top of camera, unplug the ribbon by pulling on it.

    • Disconnect the white plug connected by red and black wires by pulling on it.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Robert Manno

Miembro Desde 05/01/11

432 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 13-3, Forte Winter 2011 Miembro de Cal Poly, Team 13-3, Forte Winter 2011

CPSU-FORTE-W11S13G3

5 Miembros

8 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 2,277