Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Disassembling Canon Pixma MP480 Rear and Side Panel

Qué necesitas

  1. Disassembling Canon Pixma MP480 Rear and Side Panel, Rear and Side Panel: paso 1, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel, Rear and Side Panel: paso 1, imagen 2 de 2
    • Remove the following two Phillips screws:

    • Two 7.85 mm Phillips #1 screws

  2. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 2, imagen 1 de 1
    • Pull the back cover off by lifting up on the cover.

    • You may need to pull firmly as it requires quite a bit of force.

  3. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 3, imagen 1 de 1
    • Open the front tray.

  4. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 4, imagen 1 de 1
    • Lift the scanner compartment.

  5. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 5, imagen 1 de 1
    • After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.

  6. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 6, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 6, imagen 2 de 2
    • Push the blue lever back while twisting it clockwise in order to remove the lever from its slot.

    • After removing the lever, close the scanner compartment and the scanner cover.

  7. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 7, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 7, imagen 2 de 2
    • Use the plastic opening tool to pry open the side cover.

  8. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 8, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 8, imagen 2 de 2
    • Flip the printer so that you are facing the underside.

    • Use the plastic opening tool to remove the corner of the side panel from the pin.

    • Plastic pin.

  9. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 9, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 9, imagen 2 de 2
    • Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.

Conclusión

To reassemble your device, follow these instructions in reverse order.

6 personas más completaron esta guía.

Kevin Cole

Miembro Desde 01/17/13

116 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 19-41, Regan Winter 2013 Miembro de Cal Poly, Team 19-41, Regan Winter 2013

CPSU-REGAN-W13S19G41

4 Miembros

6 Guías creadas

2 comentarios

Where is the rest of disassembly?

bill roberts - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 1

Ultimos 30 días: 14

Todo El Tiempo: 21,120