Saltar al contenido principal

Disassembling Canon Pixma MP480 Rear and Side Panel

Qué necesitas

  1. Disassembling Canon Pixma MP480 Rear and Side Panel, Rear and Side Panel: paso 1, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel, Rear and Side Panel: paso 1, imagen 2 de 2
    • Remove the two 7.9 mm screws using a Phillips #1 screwdriver.

  2. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 2, imagen 1 de 1
    • Lift up the back cover to remove it.

    • You may need to lift firmly as it requires quite a bit of force.

    "quite a bit of force" is almost an understatement, I found 2 clips along the bottom of that rear piece, one at the far left one around the middle (indicated by an arrow on the underside of the machine) - undoing these required much persistence with a screwdriver

    Perhaps Fuzz - Contestar

    Thank you, Perhaps Fuzz. Thank you.

    Marji Zintz -

  3. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 3, imagen 1 de 1
    • Open the front tray.

  4. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 4, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 4, imagen 2 de 2
    • Open the scanner compartment.

    • Make sure the blue lever locks into place to keep the compartment open.

  5. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 5, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 5, imagen 2 de 2
    • Remove the blue lever from its slot by pushing it back and twisting clockwise.

    • Close the scanner compartment and cover.

  6. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 6, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 6, imagen 2 de 2
    • Pry open the side cover with the plastic opening tool.

  7. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 7, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 7, imagen 2 de 2
    • Flip the printer over so that you are facing the bottom of the printer.

    • Use the plastic opening tool to remove the corner of the side panel from the plastic pin.

  8. Disassembling Canon Pixma MP480 Rear and Side Panel: paso 8, imagen 1 de 2 Disassembling Canon Pixma MP480 Rear and Side Panel: paso 8, imagen 2 de 2
    • Use the plastic opening tool to loosen the side panel from the bottom of the printer.

Conclusión

To reassemble your device, follow these instructions in reverse order.

6 personas más completaron esta guía.

Kevin Cole

Miembro Desde 01/17/13

116 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 19-41, Regan Winter 2013 Miembro de Cal Poly, Team 19-41, Regan Winter 2013

CPSU-REGAN-W13S19G41

4 Miembros

6 Guías creadas

2 comentarios

Where is the rest of disassembly?

bill roberts - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 14

Todo El Tiempo: 21,120