Introducción

This guide will show you how to disassemble the back and side panel of the printer.

Partes

No se requieren partes.

Remove the following two Phillips screws:
  • Remove the following two Phillips screws:

    • Two 7.85 mm Phillips #1 screws

Agregar Comentario

Pull the back cover off by lifting up on the cover.
  • Pull the back cover off by lifting up on the cover.

    • You may need to pull firmly as it requires quite a bit of force.

Agregar Comentario

  • Open the front tray.

Agregar Comentario

  • Lift the scanner compartment.

Agregar Comentario

  • After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.

Agregar Comentario

  • Push the blue lever back while twisting it clockwise in order to remove the lever from its slot.

  • After removing the lever, close the scanner compartment and the scanner cover.

Agregar Comentario

  • Use the plastic opening tool to pry open the side cover.

Agregar Comentario

  • Flip the printer so that you are facing the underside.

  • Use the plastic opening tool to remove the corner of the side panel from the pin.

    • Plastic pin.

Agregar Comentario

  • Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Kevin Cole

Miembro Desde 17/01/13

98 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 19-41, Regan Winter 2013 Miembro de Cal Poly, Team 19-41, Regan Winter 2013

CPSU-REGAN-W13S19G41

4 Miembros

6 Guías creadas

Good job!!!!

lhitvietnam - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 18

Últimos 30 Días: 92

Todo El Tiempo: 12,991