Introducción

This guide describes the steps to opening the case.

Partes

No se requieren partes.

  1. Remove 2 screws from each side of the amplifier.
    • Remove 2 screws from each side of the amplifier.

  2. Remove 2 screws on rear of device. Slide top cover up and back from main case.
    • Remove 2 screws on rear of device. Slide top cover up and back from main case.

  3. ¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  4. Remove 3 screws on bottom of case. Remove 13 screws on rear panel.
    • Remove 3 screws on bottom of case.

    • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

  5. Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.
    • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

    • It may require some wiggling, but it should slip out of the hole and then off of the cord.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Colby

Miembro Desde 15/04/10

284 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 28-36, Regan Spring 2010 Miembro de Cal Poly, Team 28-36, Regan Spring 2010

CPSU-REGAN-S10S28G36

4 Miembros

3 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 4

Todo El Tiempo: 3,416