Repara tus cosas Comunidad Tienda

Disassembling Black and Decker BL3000S Blender Base

Introducción

As a first step to clean, maintain, or install new parts (excluding the blender blades) for the Black and Decker BL3000S the blender base must be taken apart. This guide will provide step by step instructions of how to perform this task.

Qué necesitas

  1. Disassembling Black and Decker BL3000S Blender Base, Blender Base: paso 1, imagen 1 de 2 Disassembling Black and Decker BL3000S Blender Base, Blender Base: paso 1, imagen 2 de 2

    • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

    • Lift the jar straight up from the base without tilting the jar.

    Editar

  2. Disassembling Black and Decker BL3000S Blender Base: paso 2, imagen 1 de 1

    • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

    Editar

  4. Disassembling Black and Decker BL3000S Blender Base: paso 3, imagen 1 de 2 Disassembling Black and Decker BL3000S Blender Base: paso 3, imagen 2 de 2

    • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

    • This provides access to the base screws beneath.

    Editar

  5. Disassembling Black and Decker BL3000S Blender Base: paso 4, imagen 1 de 1

    • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

    • Both screwdrivers must have a minimum of a three inch shank (length).

    • Screwdrivers with extenders will not fit down the access holes.

    Editar

  6. Disassembling Black and Decker BL3000S Blender Base: paso 5, imagen 1 de 1

    • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 3 otros colaboradores

Andrew

Miembro Desde 10/04/12

209 Reputación

4 Guías creadas

Insignias: 10

+ 7 más insignias

Equipo

Cal Poly, Team 6-34, Regan Fall 2012 Miembro de Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 8

Ultimos 30 días: 58

Todo El Tiempo: 7,672