Introducción

Whether for installing a new stereo system, or just for checking for disconnected wires, the center console of a car often needs to be removed. This guide will show you how to remove the center console of your Ford Mustang.

Partes

No se requieren partes.

Open the rear part of the middle console. Open the rear part of the middle console.
  • Open the rear part of the middle console.

Agregar Comentario

Grip the right side of the console and pull up towards the passenger seat to remove it. Grip the right side of the console and pull up towards the passenger seat to remove it.
  • Grip the right side of the console and pull up towards the passenger seat to remove it.

Agregar Comentario

Locate the two bolts under the air conditioning controls at the bottom of the face plate. Loosen these two bolts with a basic socket wrench suited for 7mm bolts.
  • Locate the two bolts under the air conditioning controls at the bottom of the face plate.

  • Loosen these two bolts with a basic socket wrench suited for 7mm bolts.

Agregar Comentario

Wedge a spudger or plastic opening tool (in place of the screwdriver shown) under the top of the face plate. Apply pressure until the corners "pop" out of place.
  • Wedge a spudger or plastic opening tool (in place of the screwdriver shown) under the top of the face plate.

  • Apply pressure until the corners "pop" out of place.

Agregar Comentario

Inspect the interior of the center console for damaged wires or other faulty components.
  • Inspect the interior of the center console for damaged wires or other faulty components.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

8 personas más completaron esta guía.

Equipo

Cal Poly, Team 15-45, Forte Fall 2012 Miembro de Cal Poly, Team 15-45, Forte Fall 2012

CPSU-FORTE-F12S15G45

5 Miembros

6 Guías creadas

Were can I get that faceplate connector and the connectors for the sterio...I have a 2010 v6 mustang

Zack - Contestar

Try using the correct tool to remove panels...

hotmail1hotmail - Contestar

The screwdriver is not required. Nor is any other tool at that point. GENTLY pull from the tabs where you removed the screws.

The faceplate will begin to loosen from the bottom up. After pulling out a few inches, push back inward about a half of an inch. This has the effect of a teeter/totter on the remaining top wedge pins. Now grasp the two knobs on the bottom of the panel (fan and temp) and loosen first the left side and then the right side. No real force required at any time and practically falls out. NO SCARS on the trim.

cheers,

dbw -

davidwest805 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 8

Últimos 7 Días: 49

Últimos 30 Días: 210

Todo El Tiempo: 8,740