Repara tus cosas Comunidad Tienda

DigiTech RP70 LED Light Replacement

Introducción

If the LED light is broken, or dead, this guide will teach you how to remove the broken component for replacement.

Qué necesitas

  1. DigiTech RP70 LED Light Replacement, Motherboard: paso 1, imagen 1 de 2 DigiTech RP70 LED Light Replacement, Motherboard: paso 1, imagen 2 de 2

    • Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.

    • Remove the four 8mm Phillips #0 screws located on the back panel.

    Editar

  2. DigiTech RP70 LED Light Replacement: paso 2, imagen 1 de 2 DigiTech RP70 LED Light Replacement: paso 2, imagen 2 de 2

    • Remove the back panel to expose the motherboard.

    Editar

  4. DigiTech RP70 LED Light Replacement: paso 3, imagen 1 de 1

    • Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

    Editar

  5. DigiTech RP70 LED Light Replacement: paso 4, imagen 1 de 1

    • Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

    Editar

  6. DigiTech RP70 LED Light Replacement, LED Light: paso 5, imagen 1 de 1

    • Desolder the back of the motherboard where the LED light is located.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

0Guía Comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 9

Todo El Tiempo: 389