Repara tus cosas Comunidad Tienda

DigiLand DL8006 Internal Ribbon Replacement

Introducción

This repair is for when the internal ribbon in their DigiLand DL8006 has worn down or broke and the screen is no longer working. This guide will assist the user with replacing the internal ribbon that lays on top of the battery, accessible at the back end of the tablet.

Qué necesitas

  1. DigiLand DL8006 Internal Ribbon Replacement, Internal Ribbon: paso 1, imagen 1 de 3 DigiLand DL8006 Internal Ribbon Replacement, Internal Ribbon: paso 1, imagen 2 de 3 DigiLand DL8006 Internal Ribbon Replacement, Internal Ribbon: paso 1, imagen 3 de 3

    • Flip the tablet to where its back is facing upward.

    • Remove the back cover by prying the sides with a plastic opening tool.

    • Lay the opened device with the circuit board exposed.

    Editar

  3. DigiLand DL8006 Internal Ribbon Replacement: paso 2, imagen 1 de 2 DigiLand DL8006 Internal Ribbon Replacement: paso 2, imagen 2 de 2

    • Remove the silver/metallic tape covering the blue and red wires overlapping the upper and lower end of the ribbon cable.

    Editar

  4. DigiLand DL8006 Internal Ribbon Replacement: paso 3, imagen 1 de 3 DigiLand DL8006 Internal Ribbon Replacement: paso 3, imagen 2 de 3 DigiLand DL8006 Internal Ribbon Replacement: paso 3, imagen 3 de 3
    Herramienta utilizada en este paso:
    Tweezers
    $4.99
    Comprar

    • Remove the ribbon cable by pulling the locking tab of the ZIF connector up and pulling the ribbon cable out with tweezers.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 2

Ultimos 30 días: 10

Todo El Tiempo: 147