Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Partes

No se especificaron partes.

  1. Este paso está sin traducir. Ayuda a traducirlo

    Before you begin, be sure to turn off your laptop and unplug it from the outlet.
    • Before you begin, be sure to turn off your laptop and unplug it from the outlet.

    • Flip over the laptop so that the bottom battery compartment faces upwards.

  2. Este paso está sin traducir. Ayuda a traducirlo

    Slide the tab below the battery to the left and hold the tab in place. Slide the tab below the battery to the left and hold the tab in place.
    • Slide the tab below the battery to the left and hold the tab in place.

  3. Este paso está sin traducir. Ayuda a traducirlo

    While holding the tab, lift the battery out of its compartment. Release the tab after removing the battery.
    • While holding the tab, lift the battery out of its compartment.

    • Release the tab after removing the battery.

  4. Este paso está sin traducir. Ayuda a traducirlo

    Loosen the module cover screw with a Phillips screwdriver.
    • Loosen the module cover screw with a Phillips screwdriver.

    • The screw is attached to the cover; do not force it out.

  5. Este paso está sin traducir. Ayuda a traducirlo

    Lift the module cover by inserting a plastic opening tool into the crevice near the screw and lift upwards. Lift the module cover by inserting a plastic opening tool into the crevice near the screw and lift upwards. Lift the module cover by inserting a plastic opening tool into the crevice near the screw and lift upwards.
    • Lift the module cover by inserting a plastic opening tool into the crevice near the screw and lift upwards.

  6. Este paso está sin traducir. Ayuda a traducirlo

    Remove the four 4mm Phillips screws fastening the first hard drive. Remove the four 4mm Phillips screws fastening the first hard drive.
    • Remove the four 4mm Phillips screws fastening the first hard drive.

  7. Este paso está sin traducir. Ayuda a traducirlo

    Slide the hard drive with your hand towards the hole where the back panel assembly screw was located (in step 5) to disconnect it. Lift the hard drive up to remove it from the case. Lift the hard drive up to remove it from the case.
    • Slide the hard drive with your hand towards the hole where the back panel assembly screw was located (in step 5) to disconnect it.

    • Lift the hard drive up to remove it from the case.

  8. Este paso está sin traducir. Ayuda a traducirlo

    Remove the four 4mm Phillips screws on the second hard drive.
    • Remove the four 4mm Phillips screws on the second hard drive.

  9. SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación

    SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación
  10. Este paso está sin traducir. Ayuda a traducirlo

    Slide the hard drive towards the edge nearest you to disconnect it. Slide the hard drive towards the edge nearest you to disconnect it.
    • Slide the hard drive towards the edge nearest you to disconnect it.

  11. Este paso está sin traducir. Ayuda a traducirlo

    Using the tab that says "THIS SIDE UP,"  pull away from the laptop to remove the hard drive. Using the tab that says "THIS SIDE UP,"  pull away from the laptop to remove the hard drive. Using the tab that says "THIS SIDE UP,"  pull away from the laptop to remove the hard drive.
    • Using the tab that says "THIS SIDE UP," pull away from the laptop to remove the hard drive.

  12. Este paso está sin traducir. Ayuda a traducirlo

    Repeat this step  for each hard drive. Unscrew the two 4mm screws from each side of the hard drive casing with a Phillips screwdriver.
    • Repeat this step for each hard drive.

    • Unscrew the two 4mm screws from each side of the hard drive casing with a Phillips screwdriver.

  13. Este paso está sin traducir. Ayuda a traducirlo

    Remove the hard drive casing.
    • Remove the hard drive casing.

  14. Este paso está sin traducir. Ayuda a traducirlo

    Unscrew the screw holding the optical drive with a Phillips screwdriver.
    • Unscrew the screw holding the optical drive with a Phillips screwdriver.

  15. Este paso está sin traducir. Ayuda a traducirlo

    Using a plastic opening tool, pull out the optical drive. Using a plastic opening tool, pull out the optical drive. Using a plastic opening tool, pull out the optical drive.
    • Using a plastic opening tool, pull out the optical drive.

  16. Este paso está sin traducir. Ayuda a traducirlo

    Unscrew three 4mm screws near the edge of the optical drive compartment with a Phillips screwdriver.
    • Unscrew three 4mm screws near the edge of the optical drive compartment with a Phillips screwdriver.

  17. Este paso está sin traducir. Ayuda a traducirlo

    Open the laptop to about a 90 degree angle and place it on its side with the empty optical drive slot pointing upwards.
    • Open the laptop to about a 90 degree angle and place it on its side with the empty optical drive slot pointing upwards.

  18. Este paso está sin traducir. Ayuda a traducirlo

    Push and hold the tab inside the optical drive's opening with your index finger. Insert a spudger between the black and silver plastic pieces that are above the tab and pry apart the two pieces. Insert a spudger between the black and silver plastic pieces that are above the tab and pry apart the two pieces.
    • Push and hold the tab inside the optical drive's opening with your index finger.

    • Insert a spudger between the black and silver plastic pieces that are above the tab and pry apart the two pieces.

  19. Este paso está sin traducir. Ayuda a traducirlo

    Slide the spudger around the palm rest to release the clips. You may hear a crackling noise; this is normal.
    • Slide the spudger around the palm rest to release the clips.

    • You may hear a crackling noise; this is normal.

    • Use caution when sliding below the mouse pad, as there are wires we must detach in the next steps.

  20. Este paso está sin traducir. Ayuda a traducirlo

    Gently lift and rotate the palm rest panel until it's upside down as it is still connected by the mouse pad wires. The mouse pad wires are still connected to the palm rest panel.
    • Gently lift and rotate the palm rest panel until it's upside down as it is still connected by the mouse pad wires.

    • The mouse pad wires are still connected to the palm rest panel.

  21. Este paso está sin traducir. Ayuda a traducirlo

    Put the spudger below the black tab of the wider cable and push up to release. Gently pull out the cable. Gently pull out the cable.
    • Put the spudger below the black tab of the wider cable and push up to release.

    • Gently pull out the cable.

  22. Este paso está sin traducir. Ayuda a traducirlo

    Insert the spudger below the black tab of the remaining cable and push up to release. Gently pull out the cable. Gently pull out the cable.
    • Insert the spudger below the black tab of the remaining cable and push up to release.

    • Gently pull out the cable.

  23. Este paso está sin traducir. Ayuda a traducirlo

    Remove the palm rest from the laptop.
    • Remove the palm rest from the laptop.

Linea de Meta

Una persona más ha completado esta guía.

Shin Sul

Miembro Desde 02/10/15

473 Reputación

3 Guías creadas

Equipo

CSU Fullerton, Team 2-6, Bruce Fall 2015 Miembro de CSU Fullerton, Team 2-6, Bruce Fall 2015

CSUF-BRUCE-F15S2G6

4 Miembros

8 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 9

Todo El Tiempo: 757