Introducción

This replacement guide will show you how to replace the auxiliary (aux) cord on your Dell VRP100 headset. Most audio-related issues will stem from the aux cord so it is important to replace it to ensure the highest audio quality.

  1. Remove the black foam padding by peeling away slowly.
    • Remove the black foam padding by peeling away slowly.

    • Remove the front and back padding from the headset by peeling away slowly.

  2. Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.
    • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.

    • Cover panel may need to be pushed in before inserting screws.

    • Remove the cover using one of the plastic opening tools, and then carefully pull it from the casing.

    • Remove the six 5.5mm PH000 screws from the cover by rotating counter-clockwise.

    • Carefully remove the lens and motherboard assembly from the white casing.

    • Separate the external connector of the auxiliary cord.

    • A spudger may be needed to separate the connector.

    • Remove the four 2.5mm PH000 screws by rotating counter-clockwise.

    • Separate the lens housing from the motherboard panel.

    • In the top right corner of the motherboard panel, peel back the yellow tape covering the bundled auxiliary cable connector using tweezers.

    • Carefully pull out the bundled cable connectors.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Chris Grabow

Miembro Desde 08/10/18

243 Reputación

2 Guías creadas

Equipo

Cal Poly, Team S17-G1, White Fall 2018 Miembro de Cal Poly, Team S17-G1, White Fall 2018

CPSU-WHITE-F18S17G1

4 Miembros

6 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 4

Últimos 30 Días: 6

Todo El Tiempo: 51