Introducción

Before removing/replacing the Dell Latitude X300 hard drive, the battery, keyboard, and palm rest/trackpad will need to be removed.

Partes

No se requieren partes.

  1. Before removing the battery from the laptop, make sure the power is off.
    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

    Agregar Comentario

  2. Slide the battery out of the laptop.
    • Slide the battery out of the laptop.

    Agregar Comentario

    • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

    Agregar Comentario

    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

    Agregar Comentario

    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

    Agregar Comentario

    • Remove the flexible ribbon from ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

    Agregar Comentario

    • Position the laptop so that the bottom is facing upward.

    • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

    Agregar Comentario

    • Return the laptop to proper position and open the screen.

    • Remove the 6 #0 4 mm screws holding in the palm rest.

    Agregar Comentario

    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

    Agregar Comentario

    • Lift up on the small ZIF connector and remove ribbon.

    • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

    Agregar Comentario

    • Remove the 4 #00 5 mm screws holding the hard drive to the case.

    Agregar Comentario

    • Carefully pull up on the hard molded plastic portion of the ribbon to detach it from the computer.

    Agregar Comentario

    • Remove the hard drive from the laptop.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Taylor Bateman

Miembro Desde 20/01/12

93 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 11-20, Maness Winter 2012 Miembro de Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Miembros

7 Guías creadas

I have to know cause its long time ago i was using this pc,

and i really forgot my HD password and dont know where to find it,sorry

Bernard Vandenberghe - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 2

Últimos 30 Días: 20

Todo El Tiempo: 8,017