Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Dell Latitude X300 Built-In Speakers Replacement

Qué necesitas

  1. Dell Latitude X300 Built-In Speakers Replacement, Battery: paso 1, imagen 1 de 1
    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

  2. Dell Latitude X300 Built-In Speakers Replacement: paso 2, imagen 1 de 1
    • Slide the battery out of the laptop.

  3. Dell Latitude X300 Built-In Speakers Replacement, Keyboard: paso 3, imagen 1 de 1
    • Remove the four 4 mm Phillips #0 screws from the bottom of the laptop.

  4. Dell Latitude X300 Built-In Speakers Replacement: paso 4, imagen 1 de 2 Dell Latitude X300 Built-In Speakers Replacement: paso 4, imagen 2 de 2
    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

  5. Dell Latitude X300 Built-In Speakers Replacement: paso 5, imagen 1 de 1
    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

  6. Dell Latitude X300 Built-In Speakers Replacement: paso 6, imagen 1 de 1
    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

  7. Dell Latitude X300 Built-In Speakers Replacement: paso 7, imagen 1 de 1
    • Remove the flexible ribbon from the ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

  8. Dell Latitude X300 Built-In Speakers Replacement, Palm Rest/Track Pad: paso 8, imagen 1 de 1
    • Position the laptop so that the bottom is facing upward.

    • Remove the three 4 mm Phillips #0 screws holding the bottom of the palm rest.

  9. Dell Latitude X300 Built-In Speakers Replacement: paso 9, imagen 1 de 1
    • Return the laptop to proper position and open the screen.

    • Remove the six 4 mm Phillips #0 screws holding in the palm rest.

  10. Dell Latitude X300 Built-In Speakers Replacement: paso 10, imagen 1 de 1
    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

  11. Dell Latitude X300 Built-In Speakers Replacement: paso 11, imagen 1 de 1
    • Lift up on the small ZIF connector and remove the ribbon.

    • If the ribbon seems stuck, gently wiggle it to remove. Do not pull the ribbon with great force.

  12. Dell Latitude X300 Built-In Speakers Replacement, Built-In Speakers: paso 12, imagen 1 de 1
    • Remove the #00 4 mm screws holding the speakers in place.

  13. Dell Latitude X300 Built-In Speakers Replacement: paso 13, imagen 1 de 1
    • Gently pull the speaker cable out.

    • If the wire is tight, wiggle it back and forth but don’t apply too much force.

    • Do not use the speaker wire to pull itself out of the connector.

  14. Dell Latitude X300 Built-In Speakers Replacement: paso 14, imagen 1 de 1
    • Pull the speakers straight up and out of the laptop.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Elai Fresco

Miembro Desde 01/20/12

7 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 11-20, Maness Winter 2012 Miembro de Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 2

Todo El Tiempo: 995