Saltar al contenido principal

Introducción

This guide walks through the steps of locating and removing the WLAN card on your Dell Latitude E4310 Latptop.

Partes

No se especificaron partes.

  1. Remove the single Phillips #1 screw. This screw will not necessarily come off of the panel. Lift up and remove with your fingernail, or a spudger, from the side of the door with the screw.
    • Remove the single Phillips #1 screw.

    • This screw will not necessarily come off of the panel.

    • Lift up and remove with your fingernail, or a spudger, from the side of the door with the screw.

  2. Remove the single Phillips #1 screw.
    • Remove the single Phillips #1 screw.

  3. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  4. Use a spudger to pry up the card. Pull the card up and out of its slot. Pull the card up and out of its slot.
    • Use a spudger to pry up the card.

    • Pull the card up and out of its slot.

  5. Pull the white and black antenna cables off of the card. Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly. Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly.
    • Pull the white and black antenna cables off of the card.

    • Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 1

Últimos 30 Días: 4

Todo El Tiempo: 110