Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the laptop and remove the small panel located above the keyboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips 1 Screwdriver, unscrew the three M2x3-mm screws located above the keyboard where the small panel was originally.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With your Phillips 1 screwdriver, unscrew the five M2.5x5-mm screws and the five M2.5x8-mm screws that lie underneath the keyboard panel.
-
Be aware there are two deeply recessed screws on both sides to the rear of this panel. There are also two screws externally on the rear face either side of the battery that hold the monitor on and pass through this panel, support the screen when you remove these. There are also two screws above the hard drive bay that need to be removed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the keyboard panel to separate the component from the rest of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you have unscrewed all the screws, push in and slide out the disk drive from the device.
-
Equipo
University of North Texas, Team S6-G5, Thompson Fall 2018 Miembro de University of North Texas, Team S6-G5, Thompson Fall 2018
UNT-THOMPSON-F18S6G5
4 Miembros
5 Guías creadas
