Introducción

Guide to separating the display from the body of the laptop.

Partes

No se requieren partes.

Power down the laptop and remove the battery.
  • Power down the laptop and remove the battery.

  • Open the laptop cover all of the way.

Agregar Comentario

Locate the notch under the cover at the top of the keyboard
  • Locate the notch under the cover at the top of the keyboard

  • Using the spudger as a lever, lift the plastic covering

  • Carefully remove the rest of the covering from right to left

Agregar Comentario

  • Unscrew the top portion of the keyboard using a #00 screwdriver

Agregar Comentario

  • Hold keyboard from the top and gently pull towards the LCD screen to remove the keyboard from the case

  • Don't pull on the keyboard too forcefully because it is attached to the motherboard with a short, thin ribbon cable

Agregar Comentario

  • Once keyboard is out of the case, lay it face-down on the track pad

Agregar Comentario

  • Using a small spudger, pull back on the black bar to release the blue lever

Agregar Comentario

  • Pull up on the metal bar connected to the socket to detach the ribbon cable

Agregar Comentario

  • Detach cables that connect the display to the body of the laptop

Agregar Comentario

  • Disconnect the black cable attached to the motherboard

Agregar Comentario

  • Close the laptop lid

  • Turn the laptop over onto its backside

  • Unscrew the two screws shown in the picture using a #00 screwdriver

Agregar Comentario

  • Face the laptop's back ports towards you

  • Unscrew the two screws labeled in the picture using a #00 screwdriver

Agregar Comentario

  • Turn the laptop over again so it's right-side up

  • Open the display, and pull the display up and out of the laptop's body

Agregar Comentario

  • Remove the circular rubber pads as outlined in the picture using a spudger

Agregar Comentario

  • Unscrew the screws that were under the rubber circles using the #00 screwdriver

Agregar Comentario

  • Carefully use a spudger to work around the edge of the screen to lift off the plastic cover

  • Be very careful while doing this as the plastic snaps easily

Agregar Comentario

  • Remove the screws outlined in the picture

Agregar Comentario

  • Carefully lift the LCD screen out of its casing

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

13 personas más completaron esta guía.

Miguel Wong

Miembro Desde 15/04/10

437 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 24-35, Regan Spring 2010 Miembro de Cal Poly, Team 24-35, Regan Spring 2010

CPSU-REGAN-S10S24G35

4 Miembros

4 Guías creadas

Check out this replacement screen at a great price on bcdelectrostore.com

http://www.bcdelectrostore.com/magento/l...

bob harris - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 15

Últimos 30 Días: 91

Todo El Tiempo: 30,049