Saltar al contenido principal

Dell Inspiron n5110 Hard Drive Replacement

Qué necesitas

  1. Dell Inspiron n5110 Hard Drive Replacement, Remove the Screws: paso 1, imagen 1 de 1
    • WARNING: Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in "Before You Begin".

    • CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

    • Remove the two screws that secure the hard-drive assembly to the system board.

  2. Dell Inspiron n5110 Hard Drive Replacement, Sliding the Hard Drive Assembly: paso 2, imagen 1 de 1
    • Slide the hard-drive assembly to disconnect it from the system-board connector.

  3. Dell Inspiron n5110 Hard Drive Replacement, Lifting the Hard-Drive Assembly: paso 3, imagen 1 de 1
    • Lift the hard-drive assembly off the system board.

  4. Dell Inspiron n5110 Hard Drive Replacement, Remove the Screws: paso 4, imagen 1 de 1
    • Remove the four screws that secure the hard drive to the hard-drive bracket.

  5. Dell Inspiron n5110 Hard Drive Replacement, Lifting the Hard Drive: paso 5, imagen 1 de 1
    • Lift the hard drive away from the hard-drive bracket.

  6. Dell Inspiron n5110 Hard Drive Replacement, Placing the Hard Drive: paso 6, imagen 1 de 1
    • Place the NEW hard drive in the hard-drive bracket.

  7. Dell Inspiron n5110 Hard Drive Replacement, Replace the Screws: paso 7, imagen 1 de 1
    • Replace the four screws that secure the hard drive to the hard-drive bracket.

  8. Dell Inspiron n5110 Hard Drive Replacement, Placing the Hard-Drive Assembly: paso 8, imagen 1 de 1
    • Place the hard-drive assembly on the system board.

  9. Dell Inspiron n5110 Hard Drive Replacement, Sliding the Hard-Drive Assembly: paso 9, imagen 1 de 1
    • Slide the hard-drive assembly to connect it to the system-board connector.

  10. Dell Inspiron n5110 Hard Drive Replacement, Replace the Screws: paso 10, imagen 1 de 1
    • Replace the two screws that secure the hard-drive assembly to the system-board.

Linea de Meta

3 personas más completaron esta guía.

Terrence15

Miembro Desde 12/18/17

79,121 Reputación

441 Guías creadas

Equipo

RampUP America, Inc. Miembro de RampUP America, Inc.

Community

42 Miembros

1,985 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 12

Ultimos 30 días: 48

Todo El Tiempo: 2,930